Rupesh's Oral Questions

Name : Rupesh Kumar
Course : EOOW
Surveyors Name: Mr. R.M. Paddock
MCA : Southampton,01/Sept/2008

1) Machinery on board ship.
2) What type of ship it was?
3) During watch, what you will check on main engine cylinder top?
4) Indication of scavenge fire and actions to be taken.
5) Action when OMD alarm sounded.
6) Procedure for taking over watch.
7) Procedure for handing over watch.
8) If your reliever is drunk, will you hand over the watch?
9) Which type of fire extinguisher will you find on the boiler platform?
10) Procedure for boiler gauge glass blow through.
11) Boiler trips.
12) Pre-departure steering gear checks.
13) Regulation for rudder movement.
14) Emergency generator and emergency fire pump routine checks and testing.
15) Paralleling of generator and off-loading.
16) If voltage will not same, what will you do?
17) Alternator trips.
18) Preferential trips order.
19) In generator, exhaust temp of one unit is rising. What could be the cause?
20) What type of bilge pump did u have on your ship?
21) You have to transfer bilge from bilge well to bilge holding tank what will be the procedure? And where and what you record you will maintain?
22) Bilge water pumping out regulation.
23) Suppose you are transferring bilge well to bilge holding tank but level of bilge well is not going down what is the cause and what you will check.
24) If your bilge pump is of centrifugal pump how you will start the pump and before starting what you will check.
25) After stopping transfer what you will check.
26) Engine room is flooded what will be your immediate action.
27) On electrical fire which type of fire extinguisher will you use.
28) On oil fire which type of fire extinguisher you will use.
29) Disadvantage of DCP extinguisher.
30) What precaution should be taken while using co2 extinguisher.

Time Taken -30 mins Result : Pass