Tanmoy's Orals Questions

Name : Tanmoy Mitra
Course : EOOW
Surveyors Name: Mr. D.A.Thorington.
MCA : Southampton,08/Sept/2008
1) Describe your ship.
2) Describe the Machinery onboard.
3) Describe taking over watch procedure.
4) What type of extinguisher is used fro MSB fire?
5) What special features on MSB enables application of this extinguisher?
6) Action to be taken when MSB Fire cannot be bought under control

7) Indication ,Causes,and action of scavenge fire affecting one unit.

8) What steps are taken to control scavenge fire affecting more than one unit?

9) After a few days of successfully tackling a scavenge fire,a M/E unit shows high bearing temperature,followed by an OMD alarm,What condition is generating in the engine?

10)Cause and action to be taken to curb the occurance of a crankcse explosion.

11)Routine Checks on a Purifier

12)Causes of over flow

13) Steering gear pre-departure checks

14) What effect will air in the system cause?

15) What are the features checked in a Steering gear drill and what is the frequency of occurance?

16)Procedure for pumping out machinery space bilges

17)How to test for the correct functioning of the 15 ppm monitor?

18)Regulations for discharge

19)Bilge level not going down

20)Centrifugal pump not taking suction

21) Unexpected Bilge level rising,Actions to be taken

22)Alternator Engine starting procedure

23)What parameters are to be checked?

24)One unit showing Low Exhaust temperature,Reason

25)How do you test an injector?

26)Synchronising generators.

27)How is load sharing affected?

28)Safety trips on the MSB

29)Describe the preferential trip giving the sequence of load shedding.

30)How to start Air Compressor in Manual mode?

31)Reason for draining Air bottles.

32)Boiler Routine Checks.

33)Starting up Boiler from cold.

34)Safety trips on Boiler.

35)Reasons for Pre-purging of Boiler.

36)Procedure for blowing through the gauge glass.

37)Actions to be taking is gauge glass is showing low water level.

38)How will you release excess steam pressure from the boiler?

39)At what pressure is the Boiler Safety Valve set.

40)Checks to be carried out on the Energency generator.

41)What load is the Emergency generator automatically supposed to take up.

42)What is the ISM code?

43)How is it implemented on the Ship?

44)Who is the DPA ?

45)What are his functions?

46)Checks before CO2 flooding?

47)Procedure for re-entry.

48)What is COSWP?

49)Checks before enclosed place enrty?

50)Dangers present in enclosed space.

51) What are the MSNs?

Time taken - 50 mins Result - Pass